PUMP Series Monitors
Tuesday November 21, 2006. 05:49 AM | Audio Hardware |
The PUMP Series monitors are built with a thick 25mm faceplate and solid, rear ported speaker cabinets for powerful low frequency response and durability. The PUMP Series offers a choice of a 6" or 8" mineral-filled polypropylene cone with a high temperature voice coil and damped rubber surrounds coupled with high-efficiency ferrofluid-cooled natural soft dome tweeters with a dedicated filter for an exceptionally clean sound. Two high signal-to-noise ratio amplifiers (dedicated woofer and tweeter) with a fourth order electronic crossover circuit provides a smooth frequency response and SPLs up to 91 dB. The PUMP 6a features 120W of total power and a frequency response of 45Hz to 20kHz and the PUMP 8a features 150W of power and extends the low frequency down to 40Hz.
The PUMP Series are fully magnetically shielded, include a convenient front volume control, and rear XLR balanced and 1/4" unbalanced inputs. Also included is a delay protection circuit to avoid pops and noise during power-up, making them the perfect solution for the computer-based digital recording studio.
The PUMP 6a sells for $449 per pair and the PUMP 8a sells for $529 per pair.
Add your comment! | |
![]() |
You must be logged in as a registered member to use this feature!
Share this news | |
![]() |
Buy
online at: |